How To Calculate The Data Transfer Rate? Know More About Computer Language Processing!

How To Calculate The Data Transfer Rate? Know More About Computer Language Processing!

Data Transfer Rate or DTR is the rate at which data is transferred from one device to another Shop Journey Blog. It doesn’t involve vigorous use of mathematical formulae and hectic calculations to calculate a data transfer rate. It can be seen as the speed of data transfer from a place to another. In general words, greater the bandwidth of a network path higher or more is the data transfer rate.

Image result for Know More About Computer Language Processing!

How is it done?

In telecommunication language, data transfer is referred to in bits’ form. For instance, low internet connectivity would be termed as 32.66 kilobits per second or 32.66kbps. All the network switching modes are planned in the terabit ranges. In the traditional telecommunication system, the DTR system is measured in the character’s system or block system. The data transfer time limit between a microprocessor or RAM devices such as Hard Disk and the CD-ROM is generally measured in milliseconds. 

In computer language, the data transfer is measured in the form of bytes per second. The highest data transfer rate, which is there in any system, is 14 terabits per second on a single optical fiber.

Now the question is how to calculate the data transfer rate? You would have to look it in terms of kilobytes, megabytes and gigabytes.  A very simple equation can calculate it, i.e., how much data is transferred and within what time or how much time did the data take to transfer the particular data. 

Image result for Know More About Computer Language Processing!

Three simple steps to calculate data transfer rate DTR

  1. To get the kilobytes, you first need to convert the megabytes and gigabytes into kilobytes or KBs. As a megabyte is rough as 1000 kilobytes, multiplying it by 1000 would give to the designated kilobytes form
  2. Now the role of time comes into play. Convert the time taken in data transfer of minutes into seconds. Since one minute constitutes 60 seconds, multiply the given number of minutes into 60. If time is exceeded into hours, multiply it by 60 twice. 
  3. After you get the time in seconds and data transfer in kilobytes, divide this data transfer size by several seconds. That would give you the data transfer rate or DTR.

Always remember that data transfer is always in “bits per second” and not “bytes per second.” For instance, 50mbps doesn’t imply 50 megabytes per second but rather 50 megabits per second. So while calculating the data transfer rate, always covert the data into bits and time into seconds. Also, remember that 1 byte equals 8 bits.

The calculations:

But here you cannot imply that 3 GB of the file by multiplying by 8 would give the results in bytes. NO. To covert the gigabyte file into bits, you will have to multiply 3GBx1024x1024x1024x8 to get the result as 25,769,803,776 bits. Make sure that you always convert the file in kilobyte form before calculating the rate. 

In some cases, even the data converted to the kilobytes also gives the data transfer rate. In the above-briefed steps on how to calculate the data transfer rate, the file is converted to kilobytes only. But in some cases, where it`s specified that the result has to be achieved in bits form, there you will have to convert the file into bits.